Installation Instructions:

1.  Download the file "Wind02Setup.exe"
2.  Run "Wind02Setup.exe"


*************************  Version 6.9 (July 2007) ***************************
1. Vista-ready.

*****************************  Version 6.8 ***********************************
1. Program wasn't interpolating the values for Figure 6-11 correctly (zone 1).

*****************************  Version 6.7 ***********************************
1. Lifted restriction on Main Wind Force Resisting Systems not being allowed 
   to be classified as open.

*****************************  Version 6.6 ***********************************
1. Monoslope Roofs over Open Buildings was getting a divided by 0 error when 
   the roof angle is equal to 30.

*****************************  Version 6.5 ***********************************
1. Gust factors were not included in roof overhang pressures; reference Figure
   6-10.

*****************************  Version 6.4 ***********************************
1. #Ref error for Figures 6-18, Figure 6-20, Figure 6-3
2. In Figure 6-11, Zone 1 was missing the calculations.

*****************************  Version 6.3 ***********************************
1. For Simplified Procedure of components and Cladding, in the dialog box the 
   table 6-3 was being referenced and it should have been Figure 6-3.
2. Updated the help file and the manual to show the same information.
 
*****************************  Version 6.2 ***********************************
1. In the analytical method for components and cladding on a building taller 
   than 60'.  On the last page of the output, "Design Windward Wall Wind 
   Pressures, p, Equation 6-23 for Zone 5," labels "p-" and "p+" in the last 
   two columns are reversed.  

*****************************  Version 6.1 ***********************************
1. The topographical factor K1 was using a value of .50 for exposure B.  It 
   should’ve been using 0.95.


********************ATTENTION!**************************************************

This is the latest installation for the program, however additional updates or 'patches' may be available from:

ftp://ftp.digitalcanal.com/Structural/Patches/